Guides
How to Adjust Counterweight on a Turntable Without a Scale
You can set tracking force accurately without buying a stylus scale. This guide shows how to float the tonearm, zero the counterweight dial, dial in the right force for your cartridge, and check the result by ear, plus a simple coin method if your deck has no dial.
Quick Answer
To adjust the counterweight without a scale, first turn the counterweight until the tonearm floats level in the air. Then turn only the numbered ring to zero, without moving the weight. Finally rotate the whole counterweight until the ring shows your cartridge's recommended force, usually between 1.5 and 2.5 grams.
How this guide was put together
This guide is based on manufacturer manuals, published specifications and widely used audio reference standards. Mandrillis does not run hands-on tests for these guides, so treat figures as typical values and check the manual for your own gear before changing settings.
What the Counterweight Actually Does
The counterweight is the round weight on the back end of the tonearm. It balances the weight of the cartridge on the front end. How far you screw it forward or back sets how hard the stylus presses on the record.
That pressing force is called tracking force. It is measured in grams. Too little and the stylus skips. Too much and it wears records and the stylus faster.
- Most moving magnet cartridges track between 1.5 and 2.5 grams.
- DJ cartridges often sit higher, around 3 to 5 grams.
- Your cartridge's manual or box lists the exact range. Use the middle of it.
Before You Start: Prep the Turntable
Good results depend on a stable, level setup. Spend two minutes on these steps first, or the balance you set will be off.
- Place the turntable on a solid, level surface. Check with a bubble level on the platter.
- Remove the stylus guard from the cartridge.
- Set the anti-skate dial to zero for now.
- Make sure the cartridge and headshell are fully attached.
- Keep the platter still and the power off while you work.
Step-by-Step: Set the Counterweight Using the Dial
Most turntables with an adjustable counterweight have a numbered ring on the front of the weight. That ring is your scale. It works well as long as you zero it first.
Step 1: Float the Tonearm Level
Unlock the tonearm from its rest and hold it gently by the headshell. Lift the cue lever down so the arm can move freely.
Turn the counterweight forward or backward until the arm floats level in the air when you let go. It should hover without rising or dropping, like a seesaw in balance. Keep one finger near the stylus so it never drops onto the platter.
Step 2: Zero the Dial Without Moving the Weight
Put the tonearm back on its rest and lock it. Now hold the counterweight still with one hand.
With the other hand, turn only the thin numbered ring until 0 lines up with the mark on the arm. The ring turns separately from the weight. If the weight moves, go back to Step 1.
Step 3: Dial In Your Tracking Force
Now turn the whole counterweight, ring and all, toward the pivot. Watch the numbers on the ring move past the mark.
Stop when the mark reads your cartridge's recommended force. For a cartridge rated 1.5 to 2.5 grams, aim for 2. The ring and weight move together from this point on.
Step 4: Match the Anti-Skate
Set the anti-skate dial to the same number as your tracking force. For 2 grams of force, set anti-skate to 2.
This is a starting point, not a perfect value. It keeps the stylus centered in the groove and stops the arm drifting toward the center.
No Numbered Ring? Try the Coin Balance Method
Some budget decks have a counterweight with no markings. You can still get close using a homemade balance and a coin of known weight.
A US penny made after 1982 weighs about 2.5 grams. A US nickel weighs about 5 grams. That gives you a simple reference.
How to Do It
Balance a flat plastic ruler on a pencil at its 6 inch mark so it sits level. Place the penny at one end, 5 inches from the pencil.
Now lower the stylus gently onto the other end of the ruler, also 5 inches from the pencil. Adjust the counterweight until the ruler sits level. At that point, the stylus is pressing with about the weight of the penny, roughly 2.5 grams.
- Use a light plastic ruler, not a heavy metal one.
- Work slowly so the stylus never slides or drops.
- For a lighter force, place the coin closer to the pencil, since the balance depends on distance as well as weight.
How to Check Your Setting by Ear
After you set the counterweight, play a record with loud, busy passages. Listen for these signs and adjust in small steps of 0.1 to 0.2 grams.
- Skipping or a buzzy, distorted sound on loud parts: add a little force.
- The cartridge body nearly touches the record: reduce the force.
- Sound is dull and heavy, with less detail: try a little less force.
- Clean, steady sound with no skips: you are in the right range.
When a Stylus Scale Is Worth Buying
The dial and coin methods are fine for most people. A small digital stylus scale still helps in a few cases, and many cost less than a new stylus.
It is worth having if you swap cartridges often, use a high-end cartridge with a narrow force range, or own an older turntable whose dial may have drifted over the years.
- Look for a scale that reads to 0.01 gram.
- Place it on the platter so it sits at the same height as a record.
- Take three readings and use the average.
- Keep magnets away from it, since some cartridges pull on metal scales.
Setting Methods Compared
Accuracy and effort for each way to set tracking force.
| Method | Accuracy | Best for |
|---|---|---|
| Numbered dial after zeroing | Good | Most decks with a marked weight |
| Coin balance with a ruler | Rough | Decks with no markings |
| Digital stylus scale | Very good | Fine tuning and cartridge swaps |
| Factory preset arm | Fixed | Fully automatic decks |
Common Mistakes to Avoid
Most counterweight problems come from rushing the zero step. Take your time there and the rest is easy.
Never set tracking force above your cartridge's maximum. Extra weight does not improve sound, and it shortens stylus life.
- Turning the weight instead of the ring when you zero the dial.
- Leaving the stylus guard on while you balance the arm.
- Balancing the arm with the anti-skate already set high.
- Using tape, coins or putty on the headshell to add weight.
Turntables With a Calibrated Counterweight Dial
Each of these models has an adjustable counterweight with a numbered tracking force ring.
Pro-Ject Debut PRO B
Mentioned
Who Should Buy It
- Pro-Ject fans who want a deck with a balanced design path and do not mind adding their own cartridge
- Listeners who prioritize a stable plinth and aluminum platter over convenience features
- Buyers who prefer manual speed control without automation
- Users building a component system around a turntable with separate phono stage
Skip It If
- You need an all-in-one turntable with built-in phono preamp and Bluetooth
- You want a complete cartridge included and clearly listed in the product data
- You require precise dimensions and weight before purchasing
We may earn a commission at no extra cost to you.
Last verified: October 2026
Technics SL-1210M5G
Mentioned
Who Should Buy It
- Turntablists who need instant, stable torque for scratching and beat juggling
- Vinyl collectors who DJ and want a trusted direct-drive mechanism
- Club and bar installs that want a proven, familiar deck at the booth
- DJs who value precise, repeatable one-button pitch switching
Skip It If
- You have no mixer or phono preamp and do not plan to buy one
- You only play digital files and never touch a physical record
- You need confirmed weight and power figures before purchasing
We may earn a commission at no extra cost to you.
Last verified: November 2026
Audio-Technica AT-LP140XP-BK Direct-Drive DJ
Mentioned
Who Should Buy It
- Turntablists who want direct-drive precision with a balanced tonearm and quartz pitch control
- Vinyl collectors who want a matched cartridge, headshell and cleaning kit in one bundle
- Home listeners who want a turntable paired with ready-to-use powered bookshelf speakers
- DJs assembling a two-turntable-and-mixer setup who need one professional direct-drive deck
Skip It If
- You need a full DJ system with a built-in mixer
- You already own bookshelf speakers or a record cleaning kit and do not need the bundle extras
- You need confirmed turntable weight before buying
We may earn a commission at no extra cost to you.
Last verified: November 2026
Keep Reading
Related guides and picks on Mandrillis:
- Best Turntables Under 500 : decks with an adjustable counterweight
- Why Does My Record Player Skip on New Records? : 8 fixes when tracking is off
- How to Set Up a Turntable at Home : the full setup from unboxing to first play
FAQs
About This Guide
Mandrillis Team
The Mandrillis editorial team researches and compares audio and music gear using manufacturer documentation, verified specs and real buyer feedback, so you can make a confident purchase without wading through marketing claims.
Read our full research methodology.